What are the advantages of the positive and negative pressure integrated plastic suction machine?

1. The combination of positive and negative pressure will make the rhombus, concave convex surface, groove surface, corners, etc. of the workpiece more three-dimensional. Positive and negative pressure forming machine 2. The positive and negative pressure plastic suction machine is transmitted to each part of the workpiece through the positive pressure heating air flow. The air flow carries the temperature when it is pressurized, and the transmission is in place. The workpiece is formed evenly and in place.

2022

Operating Instructions for Positive and Negative Pressure Plastic Forming Machine

The operating procedures of positive and negative pressure plastic suction molding machine are as follows: 1. Before starting, carefully check the power supply, control system and heating system of the positive and negative pressure plastic suction molding machine, mainly to see whether they are normal, add lubricating oil according to the instructions, and whether the buttons are in the correct position, and start the trial run as required; 2. According to the requirements in the instructions for use, correctly install the mold on the positive and negative pressure plastic suction molding machine; 3. When raw materials must be dried, they shall be dried in the oven as required; 4. Check whether the raw materials meet the use requirements of the positive and negative pressure forming machine; 5. Set mold adjustment parameters according to the specific conditions of the mold, including opening, closing, ejection and other parameters to ensure the normal, stable and safe operation of the mold; 6. Preheating the mold can be carried out by setting the required temperature according to the thickness of processing materials; 7. Only when the material temperature and mold temperature reach the preset parameters can the material be loaded. Hard objects and metal objects are strictly prohibited from entering the mold during loading. When placing, carefully check whether there are impurities and sundries in the mold; 8. Adjust the corresponding parameters according to the state of the material. During the pre processing, carefully observe the deformation state of the material, such as whether it is smooth enough and whether the color is uniform, and slowly adjust until it meets the requirements; 9. During the operation, pay attention to the changes of temperature and pressure at any time. In case of abnormal conditions, the machine must be shut down and the power must be turned off. The machine can only be used again after being repaired and recovered by the maintenance personnel.

2022

How many types of molding machines are there

According to the product series, it can be divided into: carton forming machine, carton forming machine, packing machine, cartoning machine, carton packing machine, carton unloader, etc. According to the degree of automation of the machine, it can be divided into: automatic forming machine, automatic carton forming machine, etc.

2022

Features of forming machine

Forming machine, also known as box opening machine, refers to the automatic completion of box opening, forming and lower bottom folding. At present, the lower part of the adhesive tape is pasted, the carton board folded into cardboard is opened, the bottom of the carton is folded according to a certain procedure, sealed with adhesive tape, and then sent to the special equipment of the packing machine. Automatic carton forming machine and automatic unpacking machine are the assembly line equipment for automatic unpacking, automatic folding lower cover and automatic sealing lower bottom tape of large quantities of cartons. All the machines are controlled by PLC+display screen, which is greatly convenient for operation. They are essential equipment for automatic large-scale production.

2022

< 1 2 >

Committed to research, development and production of high efficiency, high automation, cost-effective thermoforming equipment

Home
About
Products
- Thermoforming equipment
- Other series
Video
News
- Company News
- Industry News
Contact
- Contact Us
- Messages

Shantou Adwo Mechanical Technology co.,Ltd.

Contact: Mr. Zheng 13822871415

Tel：+86-0754-89651186

Address: Jinsheng 1st Road, Jinyuan Industrial Zone, Jinping District, Shantou City

E-Mail：adwo@stadwo.com

Power by：www.300.cn | SEO

News Center